BD Loops Sealer, Single Tube (Black)

BD LoopGoop Sealer (Single Tube)

Download Specs Download Manual

• Black color
• Seals asphalt and concrete driveway after saw cutting for loops
• Large size 30 ounce tube
• Also known as Loop Goop
• Single tube included     

BD Loops Shield is a tough, long lasting, flexible one-part moisture curing self-leveling hybrid sealant. BD-LS protects and shields inductance loop wire in concrete, asphalt, and other substrates. BD Loop Shield “BD-LS” is made using one of the most advanced, high performance polymer technologies available in sealants today.

BD-LS is designed to seal inductance loops installed in saw-cut slots. BD-LS exhibits excellent adhesion to concrete, asphalt, paver stones, brick, and a variety of other substrates.

Features

• Self leveling.
• 100% Solids, will not shrink. No solvents.
• UV and weathering resistant.
• Does not bubble when exposed to water.
• Can be applied to damp/wet surfaces.
• Flat Sealant tip included with each tube of sealant. Seal the groove in 1 pass from the bottom up!
• 30 fl oz. rigid plastic tube.
• V.O.C. and California Prop 65 compliant.
• Paintable.
• Resists yellowing.
• Available in Gray or Black.

Instructions

• Carefully cut the tip off the cartridge just above the nozzle threads. Thread sealant tip onto cartridge and place into quart sized caulking gun. Sealant should be applied from the bottom of the saw-cut groove. Slightly underfill the groove to be within 1/8” (3.12 mm) of the surface to prevent vehicles from tracking sealant. For easier application, pneumatic and battery powered dispensing guns are available. Do not use high speed setting on powered dispensing guns.

Curing

• BD-LS will skin over in approximately 45 minutes at 70° F (21° C) and 50% relative humidity. Temperatures below 32°F (0°C) and/or low humidity will slow skin/cure time. Strength will start to develop immediately and continue increasing for 7 days after application. However, if groove is slightly under-filled traffic is permitted immediately after application. Not designed for installation in freezing temperatures. Use BD-LG2 for cold weather installations.

Coverage per tube

• 1.25” cutting depth with 3/16″ wide blade/groove: 20ft
• 1.50” cutting depth with 3/16″ wide blade/groove: 16ft
• 1.25” cutting depth with 1/4″ wide blade/groove: 15ft
• 1.50” cutting depth with 1/4″ wide blade/groove: 12ft