Diablo DSP-7LP Low Power Vehicle Loop Detector

Diablo DSP-7LP Low Power Vehicle Loop Detector 

The DSP-7LP vehicle detector has been specifically designed for solar powered gate applications specifically for “fail safe” operations, such as on safety loops.

This detector will operate on any voltage from 10 to 30 volts AC or DC and draws approximately 1 milliampere with no vehicle on the loop. This micro-sized detector will automatically adjust its sensitivity level when used on different loop sizes. The detector loop inductance should be between 20 and 2000 microhenries.

The DSP-7LP detector has many of the same features as our standard DSP-7 but beats all competition for reliability, simplicity, and “no car” current consumption.

Features

• Designed for solar power applications
• Designed to be cross talk free between other loops
• Plug and Play
• Small profile, making it perfect for most installations
• Automatically compensates for loop and lead-in sizes
• Switchless, self adapting to most common installations
• Fail Safe Operation
• Wide low-voltage operation
• Dimensions: Height: 1.52″ Width: 2.9″ Depth: 1.56″
• Temperature: -35°F to 165°F (-37°C to 74°C)

LED Indicators: The green Power LED blinks once per second to indicate the detector is operating and powered. The red Detect LED will turn on when a vehicle is over the loop detection area.

Loop or Wire Failures: In the case of a loop circuit failure, the green LED flashes slowly (twice per second) for an open loop circuit failure. The green LED will flash fast (10 times per second) to indicate a shorted loop circuit.
Fail Safe vs Fail Secure Info: A fail safe detector will output “detect” when the loop circuit is failed. This is always useful on a safety loop. On the free exit loop this will keep the gate open until the situation is fixed. This is useful in applications where it is important to allow traffic flow to continue. A fail secure detector will never output “detect” when the loop circuit is failed. This will keep the gate closed. This is useful in high-secure areas or installations where containment is needed. The DSP-7 is a fail safe detector. Note: Never use a fail secure detector on a safety loop.

Power: This detector is powered with 10 to 30 volts AC or DC. Approximately 1 mA current. The relay contacts are rated at 1 amp maximum.

Connector: Removable 7-pin terminal block (from left to right):
1: Relay Normally Closed (NC) – contact opens for detect
2: Relay Common
3: Relay Normally Open (NO) – contact closes for detect
4: Power common
5: Power in (10 to 30 Volts AC or +DC)
6: Loop
7: Loop